Timers Spf - Dell MXL 10GbE Reference Manual

to OSPF, but you don't want OSPF to advertise routes with prefix 1.1.0.0, you can
configure the summary-address 1.1.0.0 255.255.0.0 not-advertise to filter out all
the routes fall in range 1.1.0.0/16.
Related area range
Commands

timers spf

Set the time interval between when the switch receives a topology change and starts a shortest path first
(SPF) calculation.
Syntax
timers spf delay holdtime
To return to the default, use the no timers spf command.
Parameters
delay
holdtime
Defaults
•
•
Command ROUTER OSPF
Modes
Command
Version 8.3.16.1
History
Usage Setting the delay and holdtime parameters to a low number enables the switch to
Information an alternate path quickly but requires more CPU usage.
timers throttle lsa all
Configure LSA transmit intervals.
Syntax
timers throttle lsa all {start-interval | hold-interval | max-
interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval
Open Shortest Path First (OSPFv2 and OSPFv3)
— summarizes routes within an area.
Enter a number as the delay. The range is from 0 to
4294967295. The default is 5 seconds.
Enter a number as the hold time. The range is from 0 to
4294967295. The default is 10 seconds.
delay = 5 seconds
holdtime = 10 seconds
Introduced on the MXL 10/40GbE Switch IO Module.
Set the minimum interval between initial sending and
resending the same LSA. The range is from 0 to 600,000
milliseconds.
979