Defaults
none
Command
REDIRECT-LIST
Modes
Command
Version 9.4.0.0
History
Version 8.4.2.1
Version 8.4.2.0
seq
Configure a filter with an assigned sequence number for the redirect list.
Syntax
seq sequence-number {permit | redirect {ip-address}} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]{source-port source-port| source-port-range start-
port - end-port} {destination-port destination-port|
destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
permit
redirect
ip-address
ip-protocol-
number
protocol-type
source
mask
Policy-based Routing (PBR)
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
Enter a number from 1 to 65535.
Enter the keyword permit assign the sequence to the
permit list.
Enter the keyword redirect to assign the sequence to the
redirect list.
Enter the IP address of the forwarding router.
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
Enter one of the following keywords as the protocol type:
•
icmp for internet control message protocol
•
ip for any internet protocol
•
tcp for transmission control protocol
•
udp for user datagram protocol
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x).
1009