Ip Multicast-Limit - Dell MXL 10GbE Reference Manual

Command EXEC
Modes
Command
Version 9.2(0.0)
History
Usage To debug the MLD protocol for all ports or for specified ports, use the debug
Information
ipv6 mld_host command. Displayed information includes when a query is
received, when a report is sent, when a mcast joins or leaves a group, and some
reasons why an MLD query is rejected.

ip multicast-limit

To limit the number of multicast entries on the system, use this feature.
Syntax
ip multicast-limit limit
Parameters
limit
Defaults 15000 routes.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage This feature allows you to limit the number of multicast entries on the system. This
Information number is the total of all the multicast entries on all line cards in the system. On
each line card, the multicast module only installs the maximum number of entries,
depending on the configured CAM profile.
To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate
hardware limit that exists per port-pipe. This hardware space limitation can
supersede any software-configured limit. The opposite is also true, the CAM
partition might not be exhausted at the time the system-wide route limit set by the
ip multicast-limit command is reached.
Multicast
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the desired maximum number of multicast entries on
the system. The range is from 1 to 50000.
Introduced on the MXL 10/40GbE Switch IO Module.
919