Show Interface Ets - Dell MXL 10GbE Reference Manual

Peer DCBX Status:
----------------

show interface ets

Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port ets {summary | detail}
Parameters
port-type slot/
port ets
{summary |
detail}
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
To clear ETS TLV counters, use the clear ets counters interface port-
Information
type slot/port command.
The following describes the show interface summary command shown in the
following example.
Field
Interface
Max Supported
TC Group
Number of Traffic
Classes
1446
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
Enter the port-type slot and port ETS information.
Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Interface type with stack-unit and port number.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
PMUX Mode of the MXL 10/40GbE Switch I/O Module