Debug Ospf Lsa - Allied Telesis x310-26FT Command Reference Manual

OSPF C
OMMANDS

DEBUG OSPF LSA

debug ospf lsa
Overview This command enables debugging options for OSPF Link State Advertisements
(LSA) troubleshooting. This displays information related to internal operations of
LSAs.
To enable all debugging options, specify debug ospf lsa with no additional
parameters.
The no and undebug variant of this command disable OSPF LSA debugging. Use
this command without parameters to disable all the options.
debug ospf lsa [flooding] [generate] [install] [maxage]
Syntax
[refresh]
no debug ospf lsa [flooding] [generate] [install] [maxage]
[refresh]
Mode Privileged Exec and Global Configuration
Examples awplus#
Output Figure 24-1: Example output from the debug ospf lsa command
2002/05/09 14:08:11 OSPF: LSA[10.10.10.10:10.10.10.70]: instance(0x8139cd0) 
created with Link State Update
2002/05/09 14:08:11 OSPF: RECV[LS-Upd]: From 10.10.10.70 via vlan5:10.10.10.50 
(10.10.10.10 -> 224.0.0.5)
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: Begin send queue
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: # of LSAs 1, destination 224.0.0.5
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: End send queue
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: To 224.0.0.5 via vlan5:10.10.10.50
Related terminal monitor
Commands
undebug ospf lsa
C613-50103-01 REV A
Parameter Description
flooding
Displays LSA flooding.
generate
Displays LSA generation.
install
Show LSA installation.
maxage
Shows maximum age of the LSA in seconds.
refresh
Displays LSA refresh.
undebug ospf lsa refresh
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
883