Renault Laguna III Manual page 2197

Rear axle rubber bearing: Removal - Refitting
a Assemble the support (2) of the tool (Tar. 1850).
a Fit the components of the tool (Tar. 1850) in the fol-
lowing order:
- the cup A1 (3) of the tool (Tar. 1850) on the rubber
bush,
- the cup A2 (4) of the tool (Tar. 1850) under the rub-
ber bush,
- the cup centring shaft (5) ,
- the support of the jack (2) ,
- the jack (6) of the tool (Tav. 1420-01) on its support
(2) .
a Bring the jack (6) into contact with the cup centring
shaft (5) .
a Lower the jack fully using the handle (7) .
a Raise the jack fully using the handle (7) .
Note:
If the movement of the jack is too short, repeat
the previous three steps.
a Remove:
- the (Tar. 1850),
- the rear axle rubber bush.
REAR AXLE COMPONENTS
128654
33A-30
33A