Renault Laguna III Manual page 2219

Rear track rod: Removal - Refitting
4-WHEEL STEERING
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the ball joint nut,
- the track end nut.
a Depending on their condition, replace the bolts and
the eccentric washers.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the track rod.
a Align the eccentric bolt and compensator marks.
a Tighten to torque:
- the eccentric bolt new nuts while aligning the
marks (90 N.m),
- the track rod ball joint new nut (37 N.m).
III - FINAL OPERATION.
a Refit the wheel (see 3 5 A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Run a check on the axle assemblies' geometry (see
30A, General information, Axle assemblies:
Check, page 30A-19) .
REAR AXLE COMPONENTS
33A-52
33A