Renault Laguna III Manual page 2221

Rear axle rubber bush - 4-wheel steering actuator: Removal - Refitting
4-WHEEL STEERING
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the four wheel drive actuator nuts.
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the rubber bush on the rear axle.
REAR AXLE COMPONENTS
a Refit the jack on its support as far as possible.
a Fit the tool's (Tar. 1850) components in the following
order:
- the tool (Tar. 1850) cup (6) on the rubber bush,
« marking C2 »
- the tool (Tar. 1850) cup (7) under the rear axle,
« marking C3 »
- the cup's centring shaft (8) ,
- the support (9) with the jack.
a Bring the jack's rod into contact with the cups' cen-
tring shaft.
a Lower the jack's rod using the handle.
a
Note:
The fitting dimension of the rubber bush is deter-
mined by the depth of the cup (6) , « marking
C2 » .
a Turn the jack handle to bring the cup into contact
with the cup (6) , « marking C2 » into contact with
the forged wrench.
a Remove the (Tar. 1850).
III - FINAL OPERATION.
a Refit:
- the four wheel drive actuator (see 33A, Rear axle
components, 4-wheel steering actuator: Re-
moval - Refitting, page 33A-47) ,
33A-54
33A
128650