Renault Laguna III Manual page 2216

4-wheel steering actuator: Removal - Refitting
4-WHEEL STEERING
a Remove the nut (7) from the earth strap.
WARNING
The earth strap nut is specific. Do not swap it
with other nuts.
a Disconnect the connectors (8) .
a Unclip the wiring strap (9) .
a Unclip the wiring at (10) .
REAR AXLE COMPONENTS
128336
128484
a Remove the ball joint protector (11) .
a Mark the location of the bolts (12) on the four-wheel
drive actuator.
Note:
The wiring and the actuator gaiter are areas
which should not be touched. Handle the actua-
tor by its casing.
a Remove:
- the bolts (12) from the four-wheel drive actuator,
- the four wheel steering actuator (13) .
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the four wheel drive actuator nuts.
a Check the condition of the rubber bush between the
rear axle and the four wheel drive actuator. If the
rubber bush in the forged wrench is damaged, re-
place the rubber bush (see 33A, Rear axle compo-
nents, Rear axle rubber bush - 4-wheel steering
actuator: Removal - Refitting, page 33A-53) .
33A-49
33A
128340