Renault Laguna III Manual page 2199

Rear axle rubber bearing: Removal - Refitting
a Fit the rubber bush on the rear axle.
a Assemble the bar (7) and the cup B2 (8) of the tool
(Tar. 1850)
a Fit:
- the "bar and cup" assembly on the rubber bush,
- the indexing pin (9) in the hole of the rubber bush.
REAR AXLE COMPONENTS
128652
a Refit the jack (10) on its support (11) as far as possi-
ble.
a Fit the components of the tool (Tar. 1850) in the fol-
lowing order:
- the cup B1 (11) under the rubber bush,
- the cup centring shaft (12) ,
- the support (13) with the jack (10) .
a Bring the jack into contact with the cup centring
shaft.
a Lower the jack (10) fully using the handle (14) .
a Raise the jack (10) fully using the handle (14) .
Note:
If the movement of the jack is too short, repeat
the previous three steps.
a Remove the tool (Tar. 1850).
II - FINAL OPERATION
a Refit the complete rear axle (see 33A, Rear axle
components, Complete rear axle system: Re-
moval - Refitting, page 33A-33) .
a Check the axle geometry (see 30A, General infor-
mation, Axle assemblies: Check, page 30A-19) .
a Adjust the rear axle, if necessary (see 30A, General
information, Rear axle system: Adjustment, page
30A-32) .
33A-32
33A
128651