Renault Laguna III Manual page 2245

IDENTIFICATION
1 - Marking
There are two types of identification marking on the
wheel rims:
- engraved marking for steel wheel rims,
- cast marking for alloy wheel rims.
The marking gives the main dimensional specifications
of the wheel rim.
This marking may be:
- complete, for example 6 J 15 5 CH 36,
- simplified, for example 6 J 15.
Wheel type
1 Width (in inches)
2 Rim edge profile
3 Nominal diameter (in inches)
4 Number of holes
5 Anchorage profile of the tyre
6 Offset (in mm)
There are 3 types of wheel rim edges (2) :
- those with two flat edges,
- those with two raised edges,
- those with one flat edge and one raised edge.
WHEELS AND TYRES
Wheel rim: Identification
6 J 15
6
J
15
5
CH
36
100988
2 - Installation diameter for the wheel bolts
The wheel bolts are positioned with a pitch circle diam-
eter of 114.3 mm (5 holes).
3 - Rim run-out
The maximum run-out is measured at the wheel rim
edge (7) .
Steel wheel rims: 0.8 mm
Alloy wheel rims: 0.3 mm
4 - Out-of-roundness
The maximum out-of-round value is measured on the
tyre bead bearing surface.
Steel wheel rims: 0.7 mm
Alloy wheel rims: 0.3 mm
35A-19
35A