Renault Laguna III Manual page 2193

Rear stub axle carrier: Removal - Refitting
4-WHEEL STEERING
Special tooling required
Tav. 476 Ball joint extractor.
Tightening torquesm
nut of the eccentric bolt
of the stub axle carrier
while aligning the marks
bolt of the stub axle car-
rier
nut of the ball joint of the
con rod
brake disc protector
bolts
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 33A, Rear axle components, Rear
axle components: Precautions for the repair,
page 33A-1) .
WARNING
To avoid damaging the parking brake cable protec-
tors and causing premature wear of the system, do
not handle the cables with a tool.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove the rear wheel (see 35A, Wheels and ty-
res, Wheel: Removal - Refitting, page 35A-1) .
REAR AXLE COMPONENTS
190 N.m
190 N.m
37 N.m
8 N.m
a Unclip:
- Unclip the wheel speed sensor at (1) ,
- the wheel speed sensor wiring at (2) ,
- the front brake hose at (3) .
a Remove:
- the rear brake pads (see 33A, Rear axle compo-
nents, Rear brake pads: Removal - Refitting,
page 33A-3) ,
- the brake calliper mounting (see 33A, Rear axle
components, Rear brake calliper mounting: Re-
moval - Refitting, page 33A-13) ,
- the rear brake disc (see 33A, Rear axle compo-
nents, Rear brake disc: Removal - Refitting,
page 33A-15) ,
- the brake disc protector (see Rear brake disc pro-
tector: Removal - Refitting) .
33A-26
33A
128648