Avaya DEFINITY Server CSI Maintenance Manual page 1272

SAKI Sanity Test (#53)
This is a destructive test.
This test is only run as a part of a reset board procedure. For the Media
Processor, it is necessary to use the change ip-interfaces form to disable the
Media Processor IP interface before performing this reset board procedure. Other
common circuit packs can be reset with the reset board UUCSS command which
also executes this test.
A reset of this circuit pack will take about 3 1/2 minutes.
Table 301. TEST #53 SAKI Sanity Test
Error Test
Code Result
None ABORT System resources required for this test are not available.
1015 ABORT Port is not out-of-service.
2100 ABORT System resources required for this test are not available.
2803 ABORT It is necessary to reset the board.
1 FAIL The circuit pack failed to reset.
2, FAIL The circuit pack failed to restart.
2000
1272
Issue 5 October 2002
Description/ Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Busy out the circuit pack.
2. Execute command again.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Use the change ip-interfaces form to disable the Media Processor
IP interface.
2. Execute the command again.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
Continued on next page
555-233-119