Avaya DEFINITY Server CSI Maintenance Manual page 1378

Maintenance Objects
Control Channel Looparound Test (#52)
This test queries the circuit pack for its circuit pack code and vintage and verifies
its records.
Table 352. TEST #52 Control Channel Looparound Test
Error Test
Code Result Description/ Recommendation
None ABORT System resources required for this test are not available.
2100
FAIL The circuit pack failed to return the circuit pack code or vintage.
PASS Communication with this circuit pack is successful.
0 NO The test could not relate the internal ID to the port (no board). This
BOARD could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
This should re-establish the linkage between the internal ID and the
port.
1378
Issue 5 October 2002
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Retry the command a maximum of 5 times.
2. If the problem continues, and if the circuit pack is one of the Port
circuit packs, replace the circuit pack. Otherwise, if the circuit
pack is part of the SPE, use the procedure described in
Replacing SPE Circuit Packs in Chapter 5.
3. Retry the command a maximum of 5 times.
1. Ensure that the board translations are correct. Administer the
MedPro interface if it is not already administered.
2. If the board was already administered correctly, check the error
log to determine whether the board is hyperactive. If this is the
case, the board is shut down. Reseating the board re-initializes
the board.
3. If the board was found to be correctly inserted in step 1, then
issue the busyout board UUCSS command.
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
Continued on next page