Avaya DEFINITY Server CSI Maintenance Manual page 826

Maintenance Objects
k. This error occurs whenever the point-to-point signaling link to the endpoint
goes down (except when it goes down because either the PKT-CTRL or
the PKT-BUS has failed or has been busied out by system technician).
When this error occurs, an alarm is raised against the endpoint or adjunct.
Use test station <extension> short and look at the results of the
Signaling Link Status Test (#626). If this test fails, follow the repair
procedure for Test #626. The alarm is retired when the signaling link is
reestablished to the endpoint or adjunct.
l. Certain ASAI protocol-specific cause codes are logged by switch software.
The cause code can be determined from the following formula:
If the error type is greater than 3712, the ASAI cause code is equal to the
error type minus 3712. This code was sent to the adjunct by the switch.
If the error type is less than 3712, the ASAI cause code is equal to the error
type minus 3584. This code was sent to the switch by the adjunct.
A description of the various ASAI cause values is contained in the Table
10-64. This table also contains recommended system technician actions
associated with the cause value. Further information can also be found in
the ASAI Specification (288-500-03). In addition, the Aux Data field of the
Error Log entry contains additional diagnostic information.
Table 122. ASAI Cause Values
Code Explanation
Service or Option
Not Available
0 Unrecognized
ASAIProtocol
Operation
40 Resources not
available
826
Issue 5 October 2002
Requested ASAI protocol operation is not implemented by the switch
or adjunct. Aux Data field of Error Log entry contains protocol identifier
for unrecognized operation.
1. Consult switch and adjunct documentation to determine which set
of operations is supported by the switch and the adjunct. Adjunct
administration turning off operations not implemented by the
switch may resolve the problem.
No available internal resources to service switch or adjunct request.
System transaction capacity for adjunct or switch is exceeded.
1. Re-engineering of adjunct services my be required.
Recommendation
Continued on next page
555-233-119