Maintenance Objects
Table 436. TEST #48 Station Present Test — Continued
Error
Test
Code
Result
1004
ABORT
1005
ABORT
1008
ABORT
1018
ABORT
2000
ABORT
2100
ABORT
1552
Issue 5 October 2002
Description/Recommendation
The port was seized by a valid call during the test, and the test was
aborted. Use the display port UUCSSpp command to determine the
station extension. Use the status station command to determine the
service state of the port. If the service state indicates that the port is
in use. Wait until the port is idle.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The test was aborted due to a configuration problem. This test may
not be applicable, or it may be disruptive to terminal equipment other
than a voice terminal (for example, the modem pool member or
Music On Hold).
Could not allocate a ringing circuit. Either all the ringing circuits are in
use or the ringing generator is defective or it is not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the
Error Log. If an ABORT 1008 occurs for this test on other circuit
packs as well, then the ringing generator may be defective or is
not wired correctly (see errors for RING-GEN). If it does not
occur on other ports, then all four ring phases are in use.
The test has been disabled by administration. The default for the
Test field on the Station form is y. Determine why this field has
been set to n on this station (this may be due to the brief ringing
disturbance that this test may cause).
1. To enable the test for the particular analog station being tested,
enter change station extension and set the Test? field on the
Station form to y.
Response to the test request was not received within the allowable
time period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Need help?
Do you have a question about the DEFINITY Server CSI and is the answer not in the manual?
Questions and answers