Avaya DEFINITY Server CSI Maintenance Manual page 1385

MEDPRO (Media Processor MAPD Circuit Pack)
Table 356. TEST #1381 NT Reset Test — Continued
Error Test
Code Result Description/ Recommendation
PASS The circuit pack initializes correctly.
0 NO The test could not relate the internal ID to the port (no board). This
BOARD could be due to incorrect translations, no board is inserted, an
incorrect board is inserted, or an insane board is inserted.
This should re-establish the linkage between the internal ID and the
port.
555-233-119
1. Run the Short Test Sequence.
1. Ensure that the board translations are correct. Administer the
MEDPROMEDPRO interface if it is not already administered.
2. If the board was already administered correctly, check the error
log to determine whether the board is hyperactive. If this is the
case, the board is shut down. Reseating the board re-initializes
the board.
3. If the board was found to be correctly inserted in step 1, then
issue the busyout board UUCSS command.
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
Continued on next page
Issue 5 October 2002
1385