Avaya DEFINITY Server CSI Maintenance Manual page 784

Maintenance Objects
Table 105. ATM Board DSP Test (#1293)
Error Test
Code Result Description/Recommendation
1002 ABORT Could not allocate time slots. Traffic could be heavy or time slots could be
out-of-service
Run display errors, and follow associated repair procedures for TDM-BUS.
Retry the command up to 3 times at 1-minute intervals.
1003 ABORT Could not allocate a tone detector. Too few tone detectors present or tone
detectors out-of-service.
Run display errors, and follow the repair procedures associated with any
TTR-LEV (TTR Level) errors that appear.
Make sure that there is at least one tone detector on the network that holds
the ATM-TRK circuit pack.
Resolve any TONE-PT (Tone Generator) errors listed in the Error Log.
Retry the command up to 3 times at 1-minute intervals.
1962 ABORT All DSPs are busy. This is a very unlikely event.
Retry the command up to 3 times at 1-minute intervals.
2000 ABORT Test timed out.
If the ATM-TRK circuit pack is in standby, reset the board and run the test
again after the ATM-TRK circuit pack is inserted.
Examine the Error Log for Error 1218 (bad DSP).
Run the test again.
2100 ABORT Could not allocate required system resources.
2302 ABORT Inconsistent uplink message from the ATM-TRK circuit pack.
2500 ABORT Internal system error
Retry the command up to 5 times at 1-minute intervals.
2752 ABORT Circuit pack not a TN2305A/2306A.
784
Issue 5 October 2002
Continued on next page
555-233-119