Avaya DEFINITY Server CSI Maintenance Manual page 1196

FTP the new firmware image file
The following steps are generic to most FTP programs. Use your laptop/PC/UNIX
to complete this procedure.
1. Ensure that the new firmware image file is in the same directory from which
you will launch the FTP session.
2. Type ping <source_ip_address> and press
communication link to the source board.
3. Type ftp <source_ip_address> and press
4. Log in to the source circuit pack with the same ftplogin and ftppassword
that you used in the
5. Type bin and press
This transfers files in binary format.
6. If you are downloading to the TN2501AP (VAL) circuit pack only, type cd /
and press
This command moves you from the announcement directory (default for
FTP sessions) to the root directory (/) where firmware and other files are
located.
7. Type put <filename.ext> and press
This command copies the new firmware image file to the destination
directory.
Type dir and press
Verify that the new firmware image file is on the circuit pack.
8. Type quit and press
This ends the FTP session.
Verify files
From the SAT verify that the new firmware image file is on the circuit pack.
1. Type list directory board <UUCSS> and press
The List Directory screen
2. Verify that the new firmware image file is listed in the File/Directory
Name field.
1196
Issue 5 October 2002
''Set up file system on circuit pack''
ftplogin is any temporary login for this FTP session, for example,
denver.
ftppassword is any temporary login for this FTP session, for
example, broncos.
.
Enter
.
Enter
.
Enter
.
Enter
(Screen
to verify a
Enter
.
Enter
section.
.
Enter
.
Enter
75) displays.
555-233-119