Avaya DEFINITY Server CSI Maintenance Manual page 1041

DIG-LINE (Digital Line)
Table 206. TEST #13 Voice and Control Channel Local Loop Test — Continued
Error Test
Code Result
2000 ABORT
2100 ABORT
7 FAIL
14 FAIL
15 FAIL
16 FAIL
PASS
555-233-119
Description/ Recommendation
Response to the test request was not received within the allowable time
period.
Could not allocate the necessary system resources to run this test.
1. Rerun the test at 1-minute intervals a maximum of 5 times.
Conference Test failed on primary channel. In some cases, users may not
notice disruption in service. In extreme cases, conferencing feature may not
work at all.
The primary voice channel is not transmitting properly. User impact may
range from noticing nothing to not being able to use this port.
The control channel between the processor and digital circuit pack is not
transmitting properly. User impact may range from noticing nothing to not
being able to use the port. Could also be disruptive to other users.
The secondary voice channel is not transmitting properly. User impact may
range from noticing nothing to not being able to use this port.
1. Run circuit pack tests to check the Tone Generator circuit pack and the
Tone Detector circuit pack using the test board PCSSpp command.
2. Resolve any problems that are detected on the Tone Generator circuit
pack or Tone Detector circuit pack.
3. If the Tone Generator and Tone Detector circuit packs are functioning
properly, and the test still fails, replace the Digital Line circuit pack.
Voice and Control Channel Local Loop test passed. All channels are
transmitting properly.
1. To be sure that this is not an intermittent problem, repeat this test up to
a maximum of 10 times to make sure it continues to pass.
2. If complaints persist (noisy connections for voice, corrupted data for
data transfer), examine the station, connections, and wiring.
Continued on next page
Issue 5 October 2002
1041