Avaya DEFINITY Server CSI Maintenance Manual page 1299

ISDN-SGR (ISDN-PRI Signaling Group)
Table 312. TEST #637 Remote Layer 3 Query — Continued
Error Test
Code Result
1006 ABORT
1019 ABORT
1113 ABORT
2100 ABORT
2500 ABORT
2500 FAIL
PASS
555-233-119
Description/Recommendation
This is a NORMAL ABORT. For country protocol 1 interfaces (including the
USA), either there are no B-channels administered in this signaling group, or
all B-channels in this signaling group are either out-of-service or are in a
"pending" state (PINS or PMTC, indicating that a B-channel maintenance
message for that B-channel has been sent and not yet acknowledged).
1. Administer an ISDN Trunk or PRI Endpoint Port (B-channel) in this
signaling group, or use the status trunk TRK-GRP/TRK or status
pri-endpoint <extension> command to check the state of the ISDN
Trunks or PRI Endpoint Ports associated with this signaling group. Refer
to ISDN-TRK or PE-BCHL for further details regarding service state
definitions and transitions. For systems not using country protocol 1
interfaces, there are no B-channels administered in this signaling group.
There is already a Remote Layer 3 Query in progress. This is a normal
ABORT.
1. Wait two minutes, then follow the procedures for when this test passes.
The Signaling Link is down. Therefore no messages can be sent to the
Far-end switch.
1. Examine the results of Tests #636 and #639 and follow
recommendations provided there.
2. If either test passes, it may be because the signaling link was disabled
by system technician. Verify this by using the display comm link
command. Tests #636 and #639 pass if the signaling link is not enabled.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Same as ABORT with no error code.
1. Follow the recommendations for ABORT with no error code.
Same as ABORT with no error code.
1. Follow the recommendations for ABORT with no error code.
A message was composed and sent to the Far-end switch. The ISDN PRI
specification allows up to two minutes for a reply.
1. Check the Error Log for ISDN-SGR (ISDN-PRI Signaling Group) for
errors of type 2305 for evidence of a Remote Layer 3 Query failure. If no
new errors were logged since this test was run, then this switch and the
Far-end switch processor can exchange call control messages.
2. If there is still a problem with a particular DS1 ISDN Trunk or PRI
Endpoint Port (B-channel), busyout the trunk or port and run the long
test sequence, paying particular attention to the results of Test #258
(ISDN Test Call).
Continued on next page
Issue 5 October 2002
1299