Avaya DEFINITY Server CSI Maintenance Manual page 1401

MMI-BD
Table 365. TEST #6 TSI Crosstalk Test
Error Test
Code Result
ABORT Internal system error. This is an abnormal abort.
1002 ABORT The system could not allocate time slots for the test, the traffic load on the
system is very high, or the time slots are out-of-service due to TDM-BUS
errors. Refer to
errors.
1003 ABORT The system could not allocate a tone detector for the test. The system is
oversized for the number of tone detectors present, or some tone detectors
are out-of-service.
2000 ABORT Response to the test was not received from the MMI-BD circuit pack within
the allowable time period.
2012 ABORT Internal system error. This is an abnormal abort.
2100 ABORT Could not allocate the necessary resources to run this test. This is an
abnormal abort.
FAIL The TSI was found to be transmitting in error. This causes noisy and
unreliable connections.
PASS The TSI is correctly using its allocated time slots.
555-233-119
Description/Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
''TDM-BUS (TDM Bus)''
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
1. Resolve any ''TTR-LEV (TTR Level)''
2. Resolve any ''TONE-PT (Tone Generator)''
3. If neither condition exists, retry the test at 1-minute intervals a maximum
of 5 times.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports are not in use. Reset the circuit pack by issuing the busyout
board PCSS, reset board PCSS, followed by the release board PCSS
commands.
2. If this result occurs again, replace the circuit pack.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Replace the circuit pack.
to diagnose any active TDM Bus
errors in the Error Log.
errors in the Error Log.
Continued on next page
Issue 5 October 2002
1401