Avaya DEFINITY Server CSI Maintenance Manual page 1713

TIE-TRK (Tie Trunk)
Table 506. TEST #844-848 Transmission Test — Continued
Error Test
Code Result
1115 ABORT
1900 ABORT
1901 ABORT
1905 ABORT
1906 ABORT
1907 ABORT
1913 ABORT
1914 ABORT
1915 ABORT
1918 ABORT
1919 ABORT
555-233-119
Description/ Recommendation
The near end test line on the circuit pack could not be allocated.
1. Verify that the circuit pack is in service and that port 1 is administered
and in service with the status port command.
2. retry the command at 1-minute intervals for a maximum of 5 retries.
The test completion message was not received from the circuit pack.
1. Test the TN2402/TN798 circuit packs.
This error occurs when the TN2402/TN798 circuit pack uplinks a message
that is not the proper response for this test. The anticipated uplink
messages are seize, ring or answer.
1. Verify that the Trunk is administered properly.
Intercept tone detected from far end.
1. Get the test line data from the near end and verify it with the far end.
Dial the test number manually to see if the TTL is reached. If it is not,
then either the number is wrong, or the far end is administered
incorrectly.
Reorder tone detected from far end.
1. See actions for error code 1905.
Other unexpected tone detected from far end.
1. See actions for error code 1905.
Audible Ring detected from far end.
1. See actions for error code 1905.
Unidentified interrupted tone detected from far end.
1. See actions for error code 1905
Busy tone detected from far end.
1. Since the test line at the far end was busy. Try the test again.
2. If the test continues to abort, the problem is with the far end system.
Test progress tone not removed from far end (type 105 test line only).
1. The problem is with the far end system; a technician at the far end
should test the test line (TN2402/TN798).
Unexpected far end release
1. The problem is with the far end system; a technician at the far end
should test the test line (TN2402/TN798).
Continued on next page
Issue 5 October 2002
1713