Avaya DEFINITY Server CSI Maintenance Manual page 1375

MEDPRO (Media Processor MAPD Circuit Pack)
Error Log Entries and Test to Clear Values
Table 350. DS1 Interface Circuit Pack Maintenance Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1(a) 0 Circuit pack removed or SAKI
Test (#53)
18(b) 0 busyout board UUCSS
23(c) 0
125(d) None None
257(e) 65535 Control Channel Loop Test
(#52)
1538(f) Any Hyper activity
1793 Any NIC Loss Of Signal
2049(g) Any NT PC Failure
2305 Any IP Address Inconsistency
2561 Any Ping Error
3841(h) 4358
3999(i) Any None
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
2. If ports are assigned to the circuit pack, then a minor alarm is raised. If no ports are assigned to the
circuit pack, then a warning alarm is raised. The alarm is raised after the circuit pack has been
missing for a period of 15 minutes. Warning alarms are also raised against any ports administered
on the circuit pack.
3. Minor alarms on this MO may be downgraded to warning alarms based on values set in the set
options command.
Notes:
a. Error Type 1 - indicates that the circuit pack has totally stopped functioning
or is not fully administered. The alarm is logged about 15 minutes after the
circuit pack has been removed or 11-minutes after the
To be fully administered, a MedPro circuit pack must meet all of these 4
conditions:
1. Have an entry in the circuit pack form (change circuit pack)
2. Have the MedPro IP address administered (change node-names)
555-233-119
Alarm On/Off
Level Board
Any Any
2
MIN/WRN ON
WARNING OFF
WARNING OFF
3
MIN/WRN ON
MINOR ON
3
MIN/WRN ON
3
MIN/WRN
3
MIN/WRN
3
MIN/WRN
Log Only
Issue 5 October 2002
Test to Clear Value
test board UUCSS
release board UUCSS
add ds1 UUCSS
test board UUCSS l r 2
test board UUCSS l r 2
reset board UUCSS
test board UUCSS l r 2
test board UUCSS l r 5
Continued on next page
Test (#53) fails.
SAKI
1375