Avaya DEFINITY Server CSI Maintenance Manual page 1036

Table 204. TEST #9 Digital Line NPE Crosstalk Test
Error Test
Code Result
1 ABORT
2 ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1036
Issue 5 October 2002
Description/ Recommendation
During testing of the primary information channel, system resources may
not have been available. Also, the port may have been busy during the test.
1. Check the port status. Use the display port PCSSpp command to
determine the station extension of the port. Use the status station
command to determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for this test.
You will have to wait until the port is idle.
2. If the port status is idle, then retry the command a 1-minute intervals a
maximum of 5 times.
During testing of DTDM, system resources may not have been available.
Also, the port may have been busy during the test.
1. Check if port is being used. If possible, disconnect by toggling
disconnect button on DTDM. Retry command after 1 minute.
!
WARNING:
This action will drop the call in progress.
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the
station extension or attendant number of the port. Use status station or
status attendant to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting. Attendants are
always in use (off-hook) if the handset is plugged in and the port is not
busied out.
1. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS (TDM Bus) Maintenance to diagnose
any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
Continued on next page
555-233-119