Avaya DEFINITY Server CSI Maintenance Manual page 1362

Maintenance Objects
n. Error Type 3330: LAN Critical error; critical failure in the Packet Bus
interface to the circuit pack. This failure may be due to an on-board or a
Packet Bus fault.
1. If the Packet Bus is alarmed, refer to the PKT-BUS Maintenance
2. If the Packet Bus is not alarmed, clear the alarm and restore the
3. If the problem persists, and there are no PKT-BUS alarms, then
o. Error Type 3585 - 3601: the board received misframe errors; the Aux Data
shows the last reported misframe count.
p. Error Type 3840: the circuit pack received a bad control channel message
from the switch. This error is not service-affecting, and requires no action.
The Aux Data describes the following error events:
4096
4097
4098
4099
4100
4101
q. Error Type 3841: the circuit pack detected a transient hardware logic error
(for example, program logic inconsistency). This error resolves when no
faults are detected for 100 minutes. The value in Aux Data field (4358)
indicates the type of hardware problem.
r. Error Type 3842: Bad Translation RAM Location Found error; the call
continues by using another translation location. This error is not
service-affecting and requires no action.
s. Error Type 3843: LAN Receive Parity error; the circuit pack detected an
error in a received frame from the Packet Bus. These errors are most likely
caused by a Packet Bus problem, but may be due to a circuit pack fault.
1. Determine whether the problem is isolated to this circuit pack or if
1362
Issue 5 October 2002
documentation for recommended repair procedures.
board to the Packet Bus using the following command sequence:
a. busyout board UUCSS
b. reset board UUCSS
c. test board UUCSS clear
d. release board UUCSS
replace the circuit pack. See
before removing the circuit pack.
Bad major heading
Bad port number
Bad data
Bad sub-qualifier
State inconsistency
Bad logical link
the problem is caused by Packet Bus faults (see PKT-BUS).
''Shutting down NT on the TN802''