Avaya DEFINITY Server CSI Maintenance Manual page 1392

Maintenance Objects
Table 361. TDM NIC Looparound Test (#1380) — Continued
Error Test
Code Result Description/ Recommendation
2000 ABORT Response to the test was not received in the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error.
2801 ABORT The TN802B/TN2302 Media Processor board has not been
administered on the ip-interfaces form.
ANY FAIL The test did not detect the test tone through the looparound
connection.
PASS The board is functioning properly.
0 NO No board was detected by the test.
BOARD
1392
Issue 5 October 2002
1. Retry the command at 1-minute intervals a maximum of 3 times.
1. Retry the command at 1-minute intervals a maximum of 3 times.
1. Retry the command at 1-minute intervals a maximum of 3 times.
1. Test the tone-clock in the port network that contains the media
processor under test.
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
1. Resolve either wrong board (Error 125) or no board (Error 131)
issues, if applicable.
2. Check that the board is properly translated and inserted. If so,
check for hyperactivity (Error 1538). If hyperactive, use the reset
board UUCSS command.
3. Run the test again. If it fails, the NCE chip on board may be bad.
Replace the board and retest.
Continued on next page