Avaya DEFINITY Server CSI Maintenance Manual page 776

Maintenance Objects
Table 99. ATM Board Reset (#1256) — Continued
Error Test
Code Result
2100 ABORT Could not allocate required system resources
Retry the command up to 5 times at 1-minute intervals.
2500 ABORT Internal system error
Try to reset the circuit pack (reset board UUCSS).
1 FAIL The circuit pack failed to reset
2 FAIL The circuit pack failed to restart.
Retry command.
If the problem persists, replace the ATM-TRK circuit pack.
PASS The ATM-TRK circuit pack is successfully reset.
0 NO No board detected.
BOARD
Check the error log for Error 125 (wrong board) or Error 131 (no board), and
perform the appropriate repair, if needed.
Ensure that the board is properly translated and inserted.
Check for Error 1538 (hyperactivity). If hyperactive, run reset board UUCSS.
Run the test again. If it fails, replace the ATM-TRK circuit pack, and retest.
ATM Board Error Query Test (#1259)
This nondestructive ATM Error Query Test retrieves the most severe, active, on-
and off-board problem from the ATM-TRK circuit pack's firmware and increments
error counts in the Error Log.
The test passes if there are no errors and fails otherwise. A passing test clears the
software counters; a failure increments the counter associated with the problem
that caused the failure and clears the others.
776
Issue 5 October 2002
Description/Recommendation
Continued on next page
555-233-119