Avaya DEFINITY Server CSI Maintenance Manual page 1747

TSC-ADM (Administered Temporary Signaling
Connections)
Table 519. TEST #604 TSC Heartbeat Inquiry Test — Continued
Error Test
Code Result
1149 ABORT
1181 ABORT
1182 ABORT
2000 ABORT
2012 ABORT
555-233-119
Description/ Recommendation
The ADMTSC is disabled.
1. Enable the TSC, and see if the status indicates "active."
2. Reissue the test tsc-administered command.
3. If the TSC still disabled, remove the ADMTSC from the system.
Ran out of ADMTSC resources.
1. Reissue the test tsc-administered command at 1-minute intervals a
maximum of 3 times.
The BX.25 link is down at the gateway.
1. Disable the ADMTSC.
2. Check the status of the gateway link via the status link link-no
command.
3. Once the gateway link indicates an "in-service" state, enable the
Administered TSC.
4. Reissue the test tsc-administered command.
The Administered TSC is not responding to a TSC heartbeat inquiry.
1. Retry the test tsc-administered command at 1-minute intervals a
maximum of 3 times.
2. If the problem continues to fail, obtain the status of the D-channel or
D-channel pair associated with the ADMTSC via the status sig-group
<group> command. If the D-channel is INS (that is, in-service) and the
status of the ADMTSC appears to be active, disable and enable the
ADMTSC through administration. NOTE: To disable the ADMTSC,
display the (administration) Signaling Group Form via the change
sig-group <group> command where <group> refers to the number of
the signaling group under which the suspect TSC is administered.
Change the Enable
field to y.
Enable
3. Reissue the test tsc-administered command.
4. If the test fails, check the ADMTSC node on the other side of the
network to verify that the ADM TSC is indeed active.
Internal System Error.
1. Reissue the test tsc-administered command at 1-minute intervals a
maximum of 5 times.
field to n. To enable the ADMTSC, change the
Issue 5 October 2002
Continued on next page
1747