Avaya DEFINITY Server CSI Maintenance Manual page 1701

TIE-TRK (Tie Trunk)
Table 501. TEST #6 NPE Crosstalk Test
Error Test
Code Result
ABORT
1000 ABORT
1001 ABORT
1002 ABORT
1003 ABORT
1004 ABORT
555-233-119
Description/ Recommendation
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required to run this test are not available. The trunk may
be busy with a valid call. Use the display trunk xx command to determine
the trunk group/member number of the port. Use the status trunk
command to determine the service state of the port. If the service state
indicates that the port is in use, the port is unavailable for certain tests. You
must wait until the port is idle before retesting.
1. If the port status is active, but the port is not in use (no connected
ports), check the Error Log for Error Type 1025 (see Error Log table for
description of this error and required actions). The port may be locked
up.
2. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
System resources required to run this test are not available. This could be
due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS Maintenance to diagnose any active
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR-LEV
Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT
Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
(Non-TN497 circuit packs only) The port was seized by a valid call during
the test. The test has been aborted. Use the display trunk xx command to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, the port is unavailable for certain tests.
You must wait until the port is idle before retesting.
Continued on next page
Issue 5 October 2002
1701