Avaya DEFINITY Server CSI Maintenance Manual page 1356

Maintenance Objects
Replacing the hard disk
The TN802 hard drive (Note 5 in
Table 334. Replacing the TN802 hard drive
Step Description
1. Shut down NT
2. Remove the circuit pack
3. Remove the hard drive
4. Replace the hard drive
5. Replace the circuit pack
6. Wait for initialization
Error Log Entries and Test to Clear Values
Table 335. MAPD (TN802) Error Log entries
Error Aux
Type Data
1
0 0 Any
1 (a) 0 Circuit pack removed or
SAKI Test (#53)
2 (b)
18 (c) 0 busyout board UUCSS
23 (d) 0
1356
Issue 5 October 2002
Figure 42 on page
Comments
Shut down Windows NT by either method
described in the
TN802''
Unlatch the circuit pack and remove it from
the carrier.
Remove the 2 screws and lift the hard drive
out of its mounting bracket.
Position the new hard drive in the mounting
bracket and replace the 2 screws (Step 3).
Slide the circuit pack into the slot and lock the
latching lever.
Wait for
Associated Test
Any
MIN/
WRN
WRN
WRN
1354) is field-replaceable.
''Shutting down NT on the
section.
the circuit pack to reseat (faceplate LEDs
light then go out
Windows NT boots (PC BOOT displays
on the faceplate LCD)
IP Trunk application to run (IP TRK #
displays on the faceplate LCD)
Continued on next page
Alarm On/Off
Level Board
Any test board UUCSS
ON
2
OFF release board UUCSS
OFF add ds1 UUCSS
Continued on next page
Test to Clear Value