Avaya DEFINITY Server CSI Maintenance Manual page 1010

Table 191. TEST #35 Port Diagnostic Test — Continued
Error Test
Code Result
1000 ABORT
1004 ABORT
1018 ABORT
2000 ABORT
2100 ABORT
1010
Issue 5 October 2002
Description/ Recommendation
System resources required to run this test were not available. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), then
check the error log for error type 513 (refer to the Error Log table for a
description of this error and required actions). The port may be locked
up.
2. If the port status is idle, busyout and release the trunk, and then retry
the command at 1-minute intervals for a maximum of 5 times.
3. If the test continues to abort, check for wiring errors toward the CO
which may cause the trunk to lock up.
4. If the wiring is OK and the test continues to abort, replace the TN753.
The port was seized by a valid call during the test. The test has been
aborted. Use the display port PCSSpp command to determine the station
extension, attendant number, or trunk group/member number of the port.
Use the status station, status attendant, or status trunk command to
determine the service state of the port. If the service state indicates that the
port is in use, then the port is unavailable for certain tests. You must wait
until the port is idle before retesting. Attendants are always in use (off-hook)
if the handset is plugged in and the port is not busied out.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Test has been disabled by trunk group administration. Verify that the
Maintenance Tests?
enable the test, issue the change trunk-group x command where "x"
equals the number of the trunk group to be tested. Then change the entry in
the Maintenance Tests?
Response to the test request was not received within the allowable time
period.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
field on the Trunk Group Form is set to n. To
field on the form to y.
Continued on next page
555-233-119