Avaya DEFINITY Server CSI Maintenance Manual page 1711

TIE-TRK (Tie Trunk)
Table 505. TEST #74 Tie Trunk EPF Test — Continued
Error Test
Code Result
1014 ABORT
1040 ABORT
2000 ABORT
2100 ABORT
1 FAIL
2 FAIL
PASS
0 NO
BOARD
555-233-119
Description/ Recommendation
The test was aborted because the circuit pack has not been inserted into
the system.
1. Use the list configuration board command to make sure the circuit
pack is inserted in the carrier.
2. If the board is not inserted, make sure the circuit pack is inserted in the
carrier and fully seated.
This test is not performed for trunk ports administered as "access
endpoints."
1. Verify this port is an access endpoint by using the display port
command.
2. If the port has been administered as an access endpoint, this test
should abort.
Response to the test request was not received within the allowable time
period.
Could not allocate the necessary system resources to run the test. This
could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The E lead test failed due to an on-board port problem.
1. Replace the circuit pack.
The M lead test failed. The EPF has experienced an overcurrent condition,
perhaps due to the external M lead.
1. To make sure the problem is on-board, disconnect the facility from the
pack and retry the test.
2. If the test fails, replace the circuit pack. Otherwise, check the external
wiring toward the far-end PBX.
Tie Trunk EPF test is successful. This port is functioning properly.
1. If users are reporting troubles, examine loop connections to the port.
The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct. Translate the
board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish the linkage
between the internal ID and the port.
Continued on next page
Issue 5 October 2002
1711