Avaya DEFINITY Server CSI Maintenance Manual page 1316

Table of Contents

Advertisement

Table 318. TEST #6 NPE Crosstalk Test
Error
Test
Code
Result
ABORT
1000
ABORT
1001
ABORT
1002
ABORT
1003
ABORT
1004
ABORT
1018
ABORT
1117
ABORT
2000
ABORT
1316
Issue 5 October 2002
Description/ Recommendation
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
System resources required for this test are not available. The port may be in
use on a valid call. Use status station or status trunk commands to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-Bus errors. Refer to TDM-Bus Maintenance to diagnose any active
TDM-Bus errors.
1. If the system has no TDM-Bus errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present or some tone detectors
may be out-of-service.
1. Look for TTR-LEV errors in the Error Log. If present, refer to TTR-LEV
Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If present, refer to TONE-PT
Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a maximum
of 5 times.
The port has been seized by a user for a valid call. Use status station or
status trunk commands to determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Maintenance is disable on this trunk.
1. Enable maintenance by entering "y" in the "Maintenance Tests?" field on
page 2 of the change trunk-group form.
A service state audit message is outstanding.
1. Wait 2 minutes and then try again.
Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
555-233-119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents