Avaya DEFINITY Server CSI Maintenance Manual page 1518

Maintenance Objects
Table 413. TEST #104 MTP Dual Port Ram Test
Error Test
Code Result
1029 ABORT
2014
2015
2016
2017
2018
2020
2022
2024
2025
2051
1000 ABORT
1030 ABORT
2000 ABORT
2028 ABORT
2029 ABORT
FAIL
PASS
1518
Issue 5 October 2002
Description/ Recommendation
(Refer to STBY-SPE Maintenance documentation for a description of these
error codes.)
System software resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The component on which the test was to be run is on the Standby SPE. This
test may be run on this component only when it resides on the Active SPE.
1. For a recommended maintenance procedure, refer to ABORT Error
Code 1030 in STBY-SPE Maintenance documentation.
Response to the test request was not received within the allowable time
period.
System software resources required for this test are not available.
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
The dual port RAM is not functioning correctly. Communication between the
processor and MTP is lost. The system is not able to report environmental
alarms, communicate with the Standby SPE, or reboot from tape, if
necessary.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, replace the Processor circuit pack.
Dual port RAM is functioning. Communication exists between the
80286/386 Processor circuit pack and the MTP.
Continued on next page