Avaya DEFINITY Server CSI Maintenance Manual page 887

CLAN-BD (Control LAN Circuit Pack)
Invalid LAPD Frame Error Counter Test (#597)
This test is non-destructive.
CLAN detects invalid frames when it receives
a frame with a CRC error
an unrecognizable frame
a recognizable frame in an unexpected state
When the CLAN circuit pack detects an invalid LAPD frame, it increments the
Invalid LAPD Frame error counter. This test reads and clears the counter, and
verifies the repair of the problem.
Errors may indicate a
circuit pack problem
packet bus problem
problem with another circuit pack on the bus
Table 146. TEST #597 Invalid LAPD Frame Error Counter Test
Error Test
Code Result
2000 ABORT Did not receive circuit pack test response within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error.
1-10 FAIL The circuit pack detects LAPD frame errors. The error code indicates the
value of the on-board error counter.
PASS Circuit pack detects no errors.
555-233-119
Description/ Recommendation
1. Retry command at 1-minute intervals, up to 5 times.
2. If the problem persists, reset the circuit pack (reset board UUCSS).
3. If the problem persists, replace the circuit pack.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the test continues to fail, execute the Packet Interface Test (#598) (test
board UUCSS long).
3. If Packet Interface Test (#598) fails, refer to Packet Bus repair
procedures.
Continued on next page
Issue 5 October 2002
887