Avaya DEFINITY Server CSI Maintenance Manual page 967

DATA-CHL (Data Channel)
Table 176. TEST #110 Data Channel Crosstalk Test — Continued
Error Test
Code Result
1000 ABORT For this test, an Error Code of 1000 can have one of several different
meanings:
Determine if the target DATA-CHL is in use for some other function (that is,
CDR Link, System Printer Link, Journal Printer Link, PMS Link, or secondary
administration terminal connection) as described previously in the
Data Channels''
the DATA-CHL. If there are no errors, there is a high probability that the
DATA-CHL is not defective.
Proceed with the remaining steps only if it is necessary to completely test
the target DATA-CHL:
1002 ABORT For this test, an Error Code of 1002 can have one of two different meanings:
1006 ABORT System resources required to run this test are not available.
1016 ABORT Resources for the test are not available.
1018 ABORT Test disabled via software patch.
2000 ABORT Resources for the test are not available.
2003 ABORT Internal system error
555-233-119
Description/Recommendation
a. The target DATA-CHL is busy and, therefore, not available for use.
b. System resources required to run this test are not available.
c. Internal system error
section. If so, check for errors on the function that is using
1. If the target DATA-CHL is in use for some other function, busyout the
function (PRI-CDR/SEC-CDR, SYS-PRNT, PMS-PRNT/JNL-PRNT,
PMS-LINK) or the DATA-CHL (secondary administration terminal
connection only).
2. Retry the command at 1-minute intervals a maximum of 5 times.
3. Restore any busied out PRI-CDR/SEC-CDR, SYS-PRNT,
PMS-PRNT/JNL-PRNT, PMS-LINK MOs to service before moving on to
another activity.
1. System resources required to run this test are not available.
2. Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Retry the command at 1-minute intervals a maximum of 5 times.
''Status of
Continued on next page
Issue 5 October 2002
967