Avaya DEFINITY Server CSI Maintenance Manual page 1649

TBRI-TRK (TN2185 ISDN Trunk-Side BRI)
Call State Audit Test (#257)
This test is nondestructive. This test performs a call state audit on an ISDN
B-Channel, and upon successful completion, guarantees that both sides of the
interface are in a consistent call state for connections using the B-Channel. The
test can be helpful when trying to clear a hung call. If the internal call state data to
the near-end switch is different from that of the far-end switch, the call will be torn
down.
The test passes if the audit is successful.
The test fails if the board is not inserted, there is an internal system error, or if a
reply was not received within a certain amount of time.
The test aborts if the signaling link is disconnected, the request is already active,
or if the B-Channel is in an Out-Of-Service state.
Table 484. TEST #257 Call State Audit Test
Error Test
Code Result
1018 ABORT
1019 ABORT
1113 ABORT
1114 ABORT
1116 ABORT
2100 ABORT
FAIL
PASS
555-233-119
Description/ Recommendation
The test is disabled.
1. Enable the test by entering y in the
page 2 of the change trunk-group form.
An audit is already in progress.
1. Wait two minutes and try again.
The signaling link has failed, so the system cannot send any messages on
behalf of this trunk.
1. Check the results of Test #1251 (Signaling Link State Check).
The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The trunk is in an out-of-service ISDN service state.
1. A call cannot be present if the trunk is in an ISDN out-of-service state,
so a call state audit would be inappropriate. No action necessary. (Use
the status trunk command.)
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
The audit passed successfully.
Maintenance Tests?
Continued on next page
Issue 5 October 2002
field on
1649