E-Dig-Bd (Multi Application Platform Board) - Avaya DEFINITY Server CSI Maintenance Manual

E-DIG-BD (Multi Application Platform Board)

E-DIG-BD (Multi Application
Platform Board)
MO Name (in
Alarm Log)
DIG800-BD
DIG800-BD
1. Where P is the port network number (1 for PPN); C is the carrier designation (for
example, A, B, or C); and SS is the address of the slot in the carrier where the circuit
pack is located (for example, 01, 02, ...).
The maintenance strategy for DIG800-BD is the same as the one described for
MO-COMBD (MO-XXX-BD). Maintenance testing of the common circuit pack is
handled by on-board firmware and SPE-controlled tests. Maintenance software
queries the firmware for error and alarm information, status, and test results. The
firmware automatically reports error conditions that will result in SPE-controlled
testing.
Board Insertion
The switch makes an additional board query if any of the following circuit packs
are inserted:
Circuit Pack
TN754
For any of the above initial board up-links, the switch sends queries requesting
additional data from the board for administration purposes, while also telling the
board the switch software release and the system type.
For the native mode, the response to the board query downlink messages
consists of several CCMS uplink messages that identify the true board code,
vintage, suffix, emulation type, and the number of reserved slots it needs.
Hyperactivity
The common circuit pack is considered "hyperactive" if the service dispatcher
receives 200 up-link messages from the circuit pack in a 10-second period. Since
MAPD has 32 ports, the hyperactivity limit is increased to 500 up-link messages
per 10seconds. An alarm is issued and the board taken out of service when the
limit reaches 400 or when it hits 500 up-link messages in 10 seconds.
555-233-119
Alarm
Level Initial Command to Run
MIN test board PCSS sh
WRN test board PCSS sh
Vintage
49
1
Full Name of MO
MO800DIG-BD
MO800DIG-BD
Issue 5 October 2002
1151