Avaya DEFINITY Server CSI Maintenance Manual page 1611

SYS-PRNT (System Printer)
3. 4- time-out during setup attempt. Most likely due to problem with
4. internal system error. Most likely temporary/sporadic failure.
5. the data module the printer is trying to use is busy with another call.
Refer to the
recommended maintenance strategy.
c. The SYS-PRNT was interrupted because of one of the following reasons:
1. the cable to the SYS-PRNT output device is disconnected;
2. the SYS-PRNT output device is powered off;
3. the data extension to which the SYS-PRNT output device connects
4. internal software error.
Check the connectivity of the wires and cables among the wall jacket, data
module, and SYS-PRNT output device. Follow the instructions provided in
the ''Procedures for Restoring the System Printer Link''
System Technician-Demanded Tests: Descriptions
and Error Codes
When inspecting errors in the system and deciding which ones to address, always
investigate errors in the order they are presented in the table below. By clearing
error codes associated with the Link Retry Test, for example, you may also clear
errors generated from other tests in the testing sequence.
Order of Investigation
Link Tear Down Test (#213)
Link Retry Test (#215)
Link Tear Down Test (#213)
1. D = Destructive; ND = Nondestructive
555-233-119
physical link or printer status.
Use the Status data module command to determine when the port
is available for testing.
''Procedures for Restoring the System Printer Link''
has been busied out;
Short Test
Sequence
Long Test
Sequence
X
X X
X X
Issue 5 October 2002
section for
section.
1
D/ND
D
ND
ND
1611