Avaya DEFINITY Server CSI Maintenance Manual page 1170

Ethernet Local Looparound Test (#1278)
This test is destructive.
Use this test to check circuitry in the data path for an Ethernet call (from the
on-board processor to the Ethernet Transceiver). This test fails if the data it
receives does not match the data it transmits.
Table 257. TEST #1278 Ethernet Local Looparound Test
Error Test
Code Result
1000 ABORT The port is in use.
2000 ABORT Did not receive circuit pack test response within the allowable time period.
2012 ABORT Internal system error.
2100 ABORT Could not allocate the necessary resources to run test.
1 FAIL Circuit pack detected failure in the Ethernet Local Looparound Test (#1278).
PASS The circuitry tests properly.
1170
Issue 5 October 2002
Description/ Recommendation
1. Determine status of port (status clan-port UUCSSpp).
2. Retry the command when the port is idle. The post may be forced to the
idle state by executing a busyout port UUCSS command.
NOTE:
The busyout port command is destructive, causing all calls and links
associated with the port to be torn down.
1. If the problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and release board UUCSS).
2. If the problem persists, replace the circuit pack.
1. Retry the command at 1-minute intervals, up to 3 times.
2. If the problem persists, escalate the problem.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
1. If the problem persists, reset the circuit pack (busyout board UUCSS,
reset board UUCSS, and reset board UUCSS).
2. If the problem persists, replace the circuit pack.
Continued on next page
555-233-119