Avaya DEFINITY Server CSI Maintenance Manual page 1642

Maintenance Objects
Layer 3 Query Test (#1243)
This test is nondestructive. This test is used to check the application layer
communications across the in-service ISDN D-Channel. The test passes if a
status enquiry message was successfully sent, fails if the signaling link is down,
and aborts if a query is already running or there is an internal error.
Table 479. TEST #1243 Layer 3 Query
Error Test
Code Result
1019 ABORT
1113 ABORT
1141 ABORT
1187 ABORT
2012 ABORT
2100 ABORT
PASS
1642
Issue 5 October 2002
Description/ Recommendation
Test is already running.
The signaling link is down.
1. Use the test port PCSSpp long command to clear any errors which
prevent establishment of the signaling link.
2. Examine the results of Test #626, which is executed with the
command. If this test aborts or fails, follow the repair procedure for the
Signaling Link Status Test.
The PKT-INT is out-of-service.
1. Consult the repair procedure for PKT-INT.
The circuit pack or port may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for TBRI-BD or
TBRI-PT.
a. If this error type is present for TBRI-PT, then release the port with
the release port PCSSpp command, and run the test again.
b. If the error is present for both TBRI-BD and TBRI-PT, then release
the circuit pack with the release board PPCSS command and run
the test again.
NOTE:
When you release the circuit pack, you release all ports associated
with it. If certain ports still need to be busied out, use the release
port PCSSpp command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5 times.
Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The switch has successfully sent a Status Enquiry message.
Continued on next page