Avaya DEFINITY Server CSI Maintenance Manual page 1251

HYB-LINE (Hybrid Line)
Hybrid Line Remote Digital Loop Around Test
(#59)
This test checks the digital control pair from the port circuit to the terminal. The
on-board microprocessor sends a message to the terminal and checks for a
proper return message. This test is repeated three times, with two out of the three
attempts passing being sufficient for this test to pass. This test runs if the station is
in-service or out-of-service.
Table 292. TEST #59 Hybrid Line Remote Digital Loop Around Test
Error Test
Code Result
ABORT
1 ABORT
1000 ABORT
2000 ABORT
555-233-119
Description/ Recommendation
Internal system error
1. Retry the command at 1-minute intervals for a maximum of 5 times.
A request for a remote station audit aborted even though all internal
resources were correctly allocated.
1. Look in the error log for error type 18 (port busied out) for this port. If
this error type is present, release the port via the release port
PCSSpp command or the release station extension command, and
then run the test again.
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals for a maximum of 5 times.
System resources required to run this test are not available. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the station extension number of the port. Use the status station
command to determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable for certain tests.
You must wait until the port is idle before retesting. Attendants are always
in use (off-hook) if the handset is plugged in and the port is not busied out.
1. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Issue 5 October 2002
1251