Avaya DEFINITY Server CSI Maintenance Manual page 791

BRI-BD/LGATE-BD (ISDN-BRI Line Circuit Pack)
Notes:
a. This error indicates the circuit pack totally stopped functioning or it was
physically removed from the system.
If the circuit pack is not in the system, insert a circuit pack (in the same slot
as the error indicates) to resolve this error. Or, if the circuit pack is in the
system and the red LED is on, follow the instructions for a Red alarm in the
''Circuit Packs''
b. This circuit pack has been busied out with busyout board PCSS.
c. Ports have been administered on this circuit pack but the circuit pack is not
physically present.
d. This error indicates transient communication problems between the switch
and this circuit pack. Execute test board PCSS and refer to the repair
procedures for the Control Channel Loop Around Test (#52).
e. An on-board hardware failure has been detected by the circuit pack.
The reported aux data values correspond to the following detected errors:
4352
4353
4355
4357
Reset the circuit pack by executing the busyout board PCSS and reset
board PCSS commands. When it is reset, the circuit pack executes a set
of tests to detect the presence of any of the above faults. The detection of
one of these errors during initialization causes the circuit pack to lock-up
and appear insane to the system. See the repair procedure in footnote (a)
for error type 1.
f. This error is reported by the circuit pack when it detects a program logic
error. While no action is required, this error may lead to errors of other
types being reported against this circuit pack.
g. This error is reported by the circuit pack when it cannot update NPE
memory and read it back. This error type can be ignored, but may lead to
errors of other types being reported against this circuit pack.
555-233-119
NOTE:
The alarm is logged approximately 11 minutes after the circuit pack
has been removed and/or SAKI Sanity Test (#53) fails.
section in Chapter 1, ''Maintenance for CSI
External RAM error
Internal RAM error
ROM Checksum error
Instruction set error
systems''.
Issue 5 October 2002
791