Err-Log (Error Log) - Avaya DEFINITY Server CSI Maintenance Manual

ERR-LOG (Error Log)

ERR-LOG (Error Log)
MO Name (in
Alarm Log)
ERR-LOG
Functional Description
The ERR-LOG MO is responsible for the sanity of the Alarm Log, the Hardware
Error Log, and the Software Error Log. If an inconsistency is detected in any one
of these logs, all logs are re-initialized and a hardware error is logged against
ERR-LOG indicating the time of inconsistency. There are no tests and no alarms
for the Error Log MO. This MO exists solely for the purpose of allowing errors to
be logged against it.
Hardware Error Log Entries and Test to Clear
Values
Error
Type
1
0
510 (a)
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer
to the appropriate test description and follow the recommended procedures.
Notes:
a. This error indicates that an inconsistency was detected in either the Alarm
Log, the Hardware Error Log, or the Software Error Log. To recover from
this error, all of the logs were cleared and re-initialized. Any alarms that
were active at the time of this error have been cleared. There is no
associated test for this error.
The Aux data value indicates when the inconsistency was found:
0
1
2
3
4
16
100
555-233-119
Alarm Level
none
Aux
Data Associated Test
Any Any
Any none
Found during a periodic audit of the Error Log
Found after an extended reboot
Found after a reboot
Found after a Reset System 3 (Cold_1)
Found after a Reset System 2 (Cold_2)
Found after a Warm Start
Found after an internal software audit
Initial Command to
Run
none
Alarm On/Off
Level Board
Any Any
none none
Issue 5 October 2002
Full Name of MO
Error Log
Test to Clear
Value
none
none
1165