Avaya DEFINITY Server CSI Maintenance Manual page 1431

OPS-LINE (DS1 OPS Line)
Table 376. TEST #36 Audit and Update Test — Continued
Error Test
Code Result
PASS
0 NO
BOARD
DS1 OPS Switchhook Inquiry Test (#312)
This test initiates the Switchhook Audit Test. The test queries the switchhook state
of the Off-Premises-Station in switch software. If the state in switch software
disagrees with the state on the DS1 Interface circuit pack. The state in the switch
software is updated to match the state on the DS1 Interface circuit pack.
Table 377. TEST #312 DS1OPS Switchhook Inquiry Test
Error Test
Code Result
ABORT Internal System Error.
1004 ABORT The port has been seized by a user for a valid call. Use the status station
command to determine when the port is available for testing.
555-233-119
Trunk translation has been updated successfully. The current trunk
states kept in the DS1 Interface circuit pack and switch software are
consistent.
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board
is inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
config command, and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the
linkage between the internal ID and the port. If this is not the case,
dispatch to check to ensure that there is a valid board inserted.
Description/ Recommendation
1. Retry the command at 1-minute intervals a maximum of 5 times.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Description/ Recommendation
Issue 5 October 2002
Continued on next page
Continued on next page
1431