Avaya DEFINITY Server CSI Maintenance Manual page 1698

Maintenance Objects
Table 500. TIE Trunk Error Log Entries — Continued
Error Aux
Type Data
2049
2305 50944
(m)
2305 57424
(m)
3 3
2561 0
3 3
2817 0
3 3
3073 0
3840 (n) 8000
3841 (n)
1. Minor alarms on this MO may be downgraded to Warning alarms based on the values used in the
set options command. If the MINOR alarm is not downgraded by the set options values, the
MINOR alarm is upgraded to a MAJOR alarm if 75 percent of the trunks in this trunk group are
alarmed.
2. Non-TN497 circuit packs only.
3. TN497 circuit packs only.
Notes:
a. Digit time-out. This occurs when the far-end PBX begins transmitting digits
too late (10 seconds) after receiving the signal indicating ready to receive
digits (if any). This can occur on an incoming immediate, wink, or delay dial
line. Check the far-end PBX to ensure a translation match at both ends.
b. Rotary dial before wink. This occurs when the far-end PBX starts dialing
before the PBX sends the wink on a wink-start or (for non-TN439 circuit
packs) on a delay-dial line. Check the far-end PBX to ensure a translation
match at both ends.
c. Rotary dial too early. This occurs when the far-end PBX starts dialing too
soon (about 50ms) after seizure on a wink start or (for non-TN439 circuit
packs) on a delay-dial line. Check the far-end PBX to ensure a translation
match at both ends.
1698
Issue 5 October 2002
Associated Test
NPE Crosstalk (#6) MAJ/MIN/
WRN
MINOR
None; Seizure
3
(#73) ; Tie Trunk
Dial (#747)
Tie Trunk Dial (#747)
3
None v WARNING
3
None MINOR
3
None
Analog Transmission
(#844-848)
Analog Transmission MINOR
(#844-848)
On/Off
Alarm Level Board
ON
1
,
3 3
OFF
3 3
OFF
OFF
OFF
Test to Clear Value
2
test port PCSSpp l r 3
test analog testcall
PCSS pp r 2
Continued on next page