Avaya DEFINITY Server CSI Maintenance Manual page 781

ATM-TRK (Circuit Emulation Service Circuit Pack)
Table 103. ATM Board Framer Looparound Test (#1260) — Continued
Error Test
Code Result Description/Recommendation
2060 ABORT Packet-bus link has failed.
Retry the command up to 3 times at 1-minute intervals.
If the test continues to abort, run display errors, and perform the repairs
associated with PKT-INT errors.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error
Retry the command up to 3 times at 1-minute intervals.
1 FAIL Test tone not detected over the looparound; packet-path test aborted.
Test the active tone clock on the port network, and verify that a tone is
reaching the ATM-TRK circuit pack. If not, correct the condition.
Run test board UUCSS long.
If the test continues to fail, replace the ATM-TRK circuit pack or transceiver.
Rerun test board UUCSS long.
2 FAIL TN1655 Packet Interface circuit pack could not detect the correct data packet.
Test the TN1655 Packet Interface circuit pack to verify that it is functioning
properly. If not, correct the condition.
Run display errors, and perform the repairs associated with DS1 CONV-BD
errors, if applicable.
Run display alarms, and perform the repairs associated with DS1 CONV-BD
alarms, if applicable.
Run test board UUCSS long.
If this test continues to fail, replace the ATM-TRK circuit pack.
Run test board UUCSS long.
3 FAIL Distorted tone returned
Test the active tone clock on the port network, and verify that a tone is
reaching the ATM-TRK circuit pack. If not, correct the condition.
Run test board UUCSS long.
If the test continues to fail, replace the ATM-TRK circuit pack.
Run test board UUCSS long.
4 FAIL Unable to create TDM-path loop.
Retry the command up to 3 times at 1-minute intervals.
If this test continues to fail, replace the ATM-TRK circuit pack.
Run test board UUCSS long.
555-233-119
Continued on next page
Issue 5 October 2002
781