Avaya DEFINITY Server CSI Maintenance Manual page 1203

FW-DWNLD (Firmware Download)
Preparation
1. See
Set up file system on circuit pack
Set up a file system on the circuit pack to accept the files before you load the files
onto the source circuit pack.
1. Log onto the switch using superuser or services login and password.
2. Type enable filesystem board <UUCSS> login <ftplogin>
<ftppassword> [size actual_size], where
and press
You will use this same ftplogin and ftppassword later in the
firmware image file''
!
FTP the new firmware image file
The following steps are generic to most FTP programs. Use your laptop/PC/UNIX
to complete this procedure.
1. Ensure that the new firmware image file is in the same directory from which
you will launch the FTP session.
555-233-119
''Hardware/software requirements''.
ftplogin is any temporary login for this FTP session (for example,
denver)
ftppassword is any temporary login, with a minimum of 7
characters, for this FTP session (for example, broncos)
the size actual_size qualifier only works with TN799C (C-LAN) and
is optional. It allows you to specify a smaller filesystem size than the
default 1MB block (maximum) allocated
.
Enter
section.
NOTE:
If the source circuit pack does not have enough available memory,
delete old files (remove file board <UUCSS> <filename>) or wait
until there is less traffic on the board.
CAUTION:
-The ftplogin and ftppassword are automatically removed after a
successful firmware download if the Remove Image File After
Successful Download field on the Status Firmware Download screen
is set to y.
-The ftplogin and ftppassword remain on the TN799DP (C-LAN) and
TN2501AP (VAL) circuit packs until they are reset or until you issue
the disable filesystem board <UUCSS> command, if the Remove
Image File After Successful Download field on the Status Firmware
Download screen is set to n.
''FTP the new
Issue 5 October 2002
1203