Avaya DEFINITY Server CSI Maintenance Manual page 1208

Aborting a firmware download
If you need to abort a scheduled (pending) firmware download:
1. Type disable firmware download and press
This command
Disable filesystem
NOTE:
Performing the following steps on the TN799DP (C-LAN) or TN2501AP
(VAL) circuit packs, removes only the ftplogin and the ftppassword. The
allocated memory for the file system remains reserved for the session.
To free up resources on the source circuit pack, you must delete the new firmware
image files and disable the filesystem.
1. Type remove file board <UUCSS> <filename> and press
image files from the source board.
2. Type list directory board <UUCSS> and press
The List Directory screen
3. Verify that the new firmware image file is not listed in the
File/Directory Name field.
4. Type disable filesystem board <UUCSS> and press
filesystem on the source circuit pack.
Troubleshooting firmware downloads
This section contains three troubleshooting sections:
''Reset 1 or 2''
''Test firmware download''
''Backing out of a firmware download''
1208
Issue 5 October 2002
Continues to download the firmware image file to circuit pack in
progress.
Aborts the remainder of the download schedule.
Clears the contents of the Status Firmware Download screen
(Screen 82).
(Screen
NOTE:
This command is only successful if no files remain on the source
circuit pack.
.
Enter
.
Enter
75) appears.
Enter
to remove
Enter
to disable the
555-233-119